Clearaudio Absolute

 

ABSOLUTE PHONO

The world's first active headshell moving coil phonostage

A tiny circuit board installed in the headshell of the tonearm amplifies the highly sensitive moving coil cartridge signal at its source. As a result, the signal to noise ratio is improved by approximately ten decibels across the entire audio bandwidth.

Clearaudio presents "Absolute Phono", the world's first active solution for all moving coil cartridges (MC). By the gain of the signal records at the source, therefore at the pickup, under help of a circuit board, the noise ratio (signal-to-noise ratio) improved the entire audio range by about ten decibels. The especially for "Absolute Phono" developed RIAA - main amplifier stage is puristical constructed with two pairs of outputs. To avoid interfering with each other, both, balanced XLR output and the unbalanced RCA (RCA) output are using separate highlevel output driver.

Läs mer på: http://clearaudio.de/ 

 

* POWER SUPPLY: Switching power supply
Input: 50 – 60 Hz / 100 - 240 V / 150mA
Output: 5.9 V / 850 mA
* SIGNAL TO NOISE RATIO: 90 dB (A-weighted)
* CHANNEL SEPARATION: 90 dB
* GAIN (@ 1KHZ): 50 dB
* MAXIMUM OUTPUT VOLTAGE: 3.5 Vrms
* THD: < 0,001 %
* OUTPUT IMPEDANCE: 64 Ohm (balanced XLR)
32 Ohm (unbalanced RCA)
* EQUALISATION: RIAA standard, deviation less than 0.1 dB
* FREQUENCY RESPONSE: 10 Hz – 100 kHz - 0.1 dB
* INPUT Clearaudio: 9-pin connector
* OUTPUT CONNECTIONS: Unbalanced (RCA phono)
Balanced (XLR)
* PIN CONFIGURATION; OUTPUT XLR:
Pin 1 = GND (Shield)
Pin 2 = Hot (+)
Pin 3 = Cold (-)
* POWER CONSUMPTION Max. consumption: 3.6 Watt
Consumption in operation: 2.6 Watt
Standby mode: 0.5 Watt
Off mode: 0.0 Watt
* TOTAL WEIGHT: Approx. 3.8 kg (Phonostage)
* DIMENSIONS (W/D/H in mm):
Headshell amplifier: 9.5 x 20.6 x 3.2
Phonostage: 240 x 145 x 56

 
 

Stäng detta fönster och återgå till föregående för att beställa!