ASR Emitter II Exclusive

Beskrivning

Integrerad förstärkare, diskret uppbyggd, 2x280watt i 8 ohm, 2x500W i 4Ohm, 700VA trafo/kanal. Relästyrd volymkontroll, 1dB volymsteg, 2 st separata nätdelar. 957.520uF Kondensatorbank, 100V Elko. Ingångar: 3st RCA, 1st WBT Cu RCA, 1st Direct RCA, 1st XLR. 1st Tape Out. Förberedd för batterinätdel.

EMITTER II
The Emitter II was developed in order to drive the most demanding loudspeakers with ease of power. The Emitter II has extremely powerful noise-free sound which further allows the huge, three dimensional sound stage and sublime clarity of this stunning amplifier take you to another place. For each channel, there is one separate power unit with two powerful PM (Philbert-Mantelschnitt) transformers with an energy saving circuit. In total, 3 transformers generate eight different voltages. Every voltage is rectified individually and pre-buffered. These voltages are used to supply separately the input amplifier, driver and output stages, as well as the control circuit. The Emitter II is connected to the power supply units with 2 double-shielded cable, each 2 meters long. The 30 contacts of the plug-in connector are designed individually for 16 ampere. The input sockets are made out of gilded massive brass. The insulator consists of high-quality Teflon. Massive silver wire Teflon coated is used for the music conductors. The 100 Amp speaker terminals with big lever grips allow up to three loudspeaker cables with cable spade connectors for Bi- or Tri-wiring. 4 mm plugs can be connected firmly and secure. To avoid any possibilities of short circuits, the pole terminals are fully -isolated and mounted with 50 mm distance.

Specifikation:

* 2×280 Watts/channel into 8 Ohms
* Total buffering capacity 957.520uF
* 6 relay driven high level inputs
* 1 direct XLR input
* 2 tape recording outputs
* Slot for phono preamplifier or balanced input.
* Volume control with relay in 1dB steps

Läs mer på: www.asraudio.de